How to test electrical circuits

This article covers testing electrical circuits on a car and how to use a circuit tester on a car.

If there is trouble without an obvious cause in any electrical component, test the circuit to find the cause.

A typical car lighting circuit- The headlampswitch alsooperates side,rear, number-plate and panellights. Power for the car'sancillary circuitscomes from the liveside of the startermotor solenoidswitch. Circuits with lamps inthem are wired inparallel, rather than inseries, so that eachlamp gets the fullmeasure of current. A control box and fusesprotect many circuits. Indicators, brake lightsand reversing lights areeach in separate circuitswith their respectiveswitches. Headlamps have twocircuits, one fordipped and one formain beam.

A typical car lighting circuit

A circuit tester is a useful and inexpensive tool for making electrical tests.

Checking a simple circuit is straightforward - the lighting circuits are among the simpler ones - but the electrical wiring in a car contains many interlinking and branching circuits, which bring complications.

All car wiring is colour-coded; unfortunately there are no national or international standards for colours. Colour codes for individual cars can be found in wiring diagrams, in the car handbook or in a service manual.

Some symbols used in wiring diagrams-

Some symbols used in wiring diagrams

Symbols are used to represent electrical components in wiring diagrams, and they are seldom labelled for clarity. Different symbols may also be used for the same component in different wiring diagrams. This chart shows the most common symbols you will encounter, some alternatives.

Study these diagrams so that you can find short cuts which save you having to check an entire circuit.

For example, if you know that the power for a suspect circuit comes from the ignition switch, and if other items fed from that switch are working, there can be no fault between the battery and the ignition. So you can save time by starting at the ignition switch.

How to use a circuit tester

A circuit tester- Test bulb in handle Crocodile earth clip Probe

A circuit tester

Connect the tester clip to the negative terminal of the battery and touch the probe to the positive one.

If the tester lamp does not light, the battery is dead (or the bulb in the tester has blown).

If it lights, try again with the clip earthed to the car body: if the lamp fails to light, the battery negative terminal is not earthed properly.

Earth the clip near the switch of the circuit being tested and touch the probe to the 'live' (battery) side of the switch. If the lamp does not light, the wiring between the battery and the switch is faulty, or a fuse has blown.

- Suitable earth

When checking a component operated
by the ignition switch, be sure that the switch is on.

If the lamp lights, turn the switch on and probe its other

side: if the lamp does not light, the switch is faulty.

If the switch works, leave it on, earth the clip near the component and probe the live side of the component. If the lamp does not light, the wiring from switch to component is faulty, or a fuse has blown.

If all of the checks so far are satisfactory, transfer the clip to the live side of the battery.

Now probe the earthed side of the component (it may be earthed by its metal body being fixed to the car body). If the lamp does not light, the component is badly earthed. If it does light, the component itself is faulty.

Stop wasting time on YouTube and get serious!

The Ultimate 20 hour car mechanics video course

Learn everything about modern cars from our new video series.

Summer special: just $20 until September 30!

Summer special: just $20 until September 30!

We build a Mazda MX5 Miata from scratch

We start by tearing down and then rebuilding the whole car.

Every part explained

There's ridiculous detail on every part. Clearly and easily explained.

All modeled in 3D

We've created the most detailed 3D model ever produced so we can show you everything working.